Twist the joints in combination in a back andforth motion, in place of by turning the lower joint in a round motion. The joints should slide smoothly in combination, and the rings in the front could be in line. After putting the upper and lower joints together, twist the bell into place after which the barrel. The barrel has a small and a huge end, and even though it is likely apparent to you, make certain that your youngest students place the barrel on in the correct course, with the bigger side of the barrel fitting onto the higher joint. Finally, place the mouthpiece on the barrel, after which the ligature and reed, in that order. Remember to keep the tenons well greased with good, clean cork grease, but do not allow too much of it to building up on the cork. Instead, wipe excess grease off before applying more in order that it doesn't get sticky. Use only the quantity of cork grease you have to as a way to get a smooth, easy connection, and do this only when it becomes difficult to slide the tenons in combination. Disassembly should follow the contrary order. Be sure that your student keeps to carry the clarinet as during meeting, raising the bridge key before twisting the joints apart. Whether gambling a wood clarinet or a plastic model, it is best to disassemble the clarinet once feasible so that the corks aren't constantly pressed, which may cause loose, wobbly tenons and eventual leaks and stuffiness.